200W LED Floodlight I Powerstar Electricals Ltd
Replace your metal halide and SON flood lights with High Power LED Floodlights
Powerstar Electricals Brand New High Powered & Energy Saving modern Slim design new in market led outdoor led high brightness SMD led light available in 200W with protection rating IP65. These light are energy saver and saving power by 80%, 120 degree beaming angle stays brighter with 6000k daylight color applicable for home, office, meeting room, hotels, shopping mall, show windows, garages, gardens, parking lots,Building sites, Construction site, shop hoarding etc. Our led lights are cost effective and maintenance free.
- Brand new and boxed
- New model in Slim design
- Optical light distribution
- No glare, no light pollution
- High lighting effect and high uniformity
- Energy saving by 80%
- Cost effective & maintenance free
- Waterproof IP65 rating
- 120 Beaming angle
- No UV or IR radiation
- High brightness SMD LED
- Long life span 50000h
- Energy rating A
- CE & ROHS
- UK seller
- Quick dispatch
- Free Shipping
- 200 Watt - Height 32.5 cm , Width 45cm
We always recommend all the Electrical fittings to be done by a Qualified Electrician.
|Brand||Power Star Electrical|
This is the information you need to know. The unit appears to be high quality and is quite large. The unit has 4 x 50w led bulbs each driven by a separate power supply ( 4 x power supplies ) The 240V end of power supplies are crimped together to a short length of 3A 3 core round cable the other end of which is sticking out of a cable gland. The low voltage end of the power supplies are wired directly to the leds and only have quite short leads. The power supplies are glued directly to the back of the rear cover. If you undo the 6 x cross head screws on the rear cover then there is just enough room to lift the cover off ( This is limited by the short cable lengths from the leds to the power supplies ). In my case this light was to replace an existing light that went faulty ( Different brand ). Sticking out of the wall i have a 6A 3 core round cable. I found that if you undo the cable gland
( Use a 17mm spanner ) Then you can push the 3A 3 core cable back inside the unit. I then pushed the 6A 3 core round cable through the cable glad and connected the two cables with a 10A terminal block. I then pushed the terminal block back inside the unit ( There is enough room ). I then tightened the cable gland, put the 6 x screws back in. Just to note that i found it easyier to mount the unit onto its wall bracket using two blots while sorting out the terminations into the 10A terminal block. You will need as 14mm spanner to tighten and adjust the angle of the spotlight.
The light output seems good enough, the reflector has a dull finish. A brighter finish may have increased the light output. I am overall happy with this product.